Toro 5 Blade Cutting Unit 03527 03528 Reelmaster 5000 5200 D 5400 D Lawn Mower Manual de Instruções de Instruções, 2005 - Portugese

Form No. 3350­282 5 and 8 Blade Reels 03527–240000001 & Up 03528–240000001 & Up for Reelmasterr 5000 Series Operator’s Manual English (EN) Contents Page Safety . Safe Operating Practices . Safety and Instruction Decals . Specifications . Set­Up Loose Parts Inspection . Adjusting Front Shield . Adjusting Rear Shield . Adjusting Cut­off Bar . Setting Height-of-Cut A. Adjusting (Parallel) Bedknife to Reel B. Setting Cutting Unit Attitude . C. Leveling Front Roller . D. Adjusting Height-of-Cut . E.

Adjusting Turf Compensation Spring . Maintenance Cutting Unit Daily Adjustments . Lubrication Backlapping the Cutting Units Servicing and Adjusting the Reel Bearings . Removing the Reel Assembly . Warranty . Figure 1 1. Location of the model and serial numbers Write the product model and serial numbers in the space below: Model No. Serial No. This manual identifies potential hazards and has special safety messages that help you and others avoid personal injury and even death. Danger, Warning, and Caution are signal words used to identify the level of hazard. However, regardless of the hazard, be extremely careful. Danger signals an extreme hazard that will cause serious injury or death if you do not follow the recommended precautions. Warning signals a hazard that may cause serious injury or death if you do not follow the recommended precautions. Caution signals a hazard that may cause minor or moderate injury if you do not follow the recommended precautions. This manual uses two other words to highlight information. Important calls attention to special mechanical information and Note: emphasizes general information worthy of special attention. Introduction Read this manual carefully to learn how to operate and maintain your product properly. The information in this manual can help you and others avoid injury and product damage. Although Toro designs and produces safe products, you are responsible for operating the product properly and safely. Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 illustrates the location of the model and serial numbers on the product. W 2003 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196 Printed in the USA 2 Safety Safe Operating Practices · Read, understand, and follow all instructions in the traction unit operator’s manual before operating the cutting unit. · Read, understand, and follow all instructions in this operator ‘s manual before operating the cutting unit. · Never allow children to operate the cutting units. Do not allow adults to operate traction unit or cutting units without proper instruction. Only trained operators who have read this manual should operate the cutting units. · Never operate the cutting units when under the influence of drugs or alcohol. · Keep all shields and safety devices in place. If a shield, safety device or decal is illegible or damaged, repair or replace it before operation is commenced.