Toro 38543 Toro 824 Power Shift Snowthrower Service Manual, 1992 - Enlarge page 1 of 105
2 of 105
3 of 105
4 of 105
5 of 105
6 of 105
7 of 105
8 of 105
9 of 105
10 of 105
11 of 105
12 of 105
13 of 105
14 of 105
15 of 105
16 of 105
17 of 105
18 of 105
19 of 105
20 of 105
21 of 105
22 of 105
23 of 105
24 of 105
25 of 105
26 of 105
27 of 105
28 of 105
29 of 105
30 of 105
31 of 105
32 of 105
33 of 105
34 of 105
35 of 105
36 of 105
37 of 105
38 of 105
39 of 105
40 of 105
41 of 105
42 of 105
43 of 105
44 of 105
45 of 105
46 of 105
47 of 105
48 of 105
49 of 105
50 of 105
From inside (document excerpt):
FORM NO. 3320-628 r MODEL NO. 38513-2000001 & UP MODEL NO. 38543-2000001 & UP MODEL NO. 38574-2000001 & UP OPERATOR’S MANUAL 624, 824 AND 828 POWER SHIFT ® SNOWTHROWERS The 624, 824 and 828 POWER SHIFT SNOWTHROWERS meet or exceed the Outdoor Power Equipment Institute’s safety standards for snowthrowers; thus, Toro proudly displays the OPEl safety seal. To assure maximum safety, optimum performance, and to gain knowledge of the product, it is essential that you or any other operator of the snowthrower read and understand the contents of this manual before the engine is ever started.
Pay particular attention to the safety alert symbol which means CAUTION, WARNING OR DANGER – “personal safety instruction. ” Read and understand the instruction because it has to do with safety. Failure to comply with instruction may result in personal injury. A The following instructions are comparable to the Instructions For Safe Snowthrowing adopted by thE3 American National Standards Institute (ANSI). The snowthrower is designed and tested to offer reasonably safe service; however, failure to comply with the following instructions MAY RESULT IN PERSONAL INJURY. WARNING: Engine exhaust contains carbon monoxide which is an odorless, deadly poison. Carbon monoxide is also known to the State of California to cause birth defects. Do not run engine indoors or in an enclosed area. 6. Adjust both skids so auger housing clears gravel or crushed rock surfaces. 7. Before starting the engine, move speed shift control to N (neutral) and ensure that auger/impeller control and traction drive control are in disengaged position. 8. Always use a grounded, three wire plug and cord to start snowthrower equipped with an electric starter. Extension cord must be connected to a properly grounded outlet. 9. Fill fuel tank with gasoline before starting the engine. Avoid spilling any gasoline. Because gasoline is highly flammable. handle it carefully. DO NOT SMOKE WHILE HANDLING GASOLINE. A. Use an approved gasoline container. B. Fill fuel tank outdoors, not indoors. NEVER ADD FUEL TO AN ENGINE THAT IS RUNNING OR HOT. Engine must be cool to reduce potential fire hazard. C. Open doors if engine will be started in the garage because exhaust fumes are dangerous and could possibly be deadly. Do not run engine indoors. D. Wipe up any spilled gasoline. Reinstall gasoline container cap and snowthrower fuel tank cap securely before starting the engine. BEFORE OPERATING 1. Read and understand the contents of this manual before operating the snowthrower. Become familiar with all controls and know how to stop the engine quickly. 2. Keep everyone, especially children and pets, away from snowthrower and area of operation. Never allow children to operate the snowthrower. Adults should operate the snowthrower only after reading this manual. Inspect area thoroughly where snowthrower will be used. Remove doormats, sleds, boards, sticks, wire, and any other foreign objects which might be picked up and thrown by the snowthrower. 4. Keep all shields and safety devices in place. If a shield, safety deNice or decal is illegible, damaged or lost, repair or replace it before beginning operation. Also, tighten any loose nuts, bolts or screws. 5. Wear adequate winter clothing and rubber boots that will ensure proper footing on slippery surfaces. Do not wear loose fitting clothing that could possibly get caught in moving parts.