Poulan Pro PP3516ACX PP4218AVX Chainsaw Owners Manual, 2006

ENGLISH Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant. www.poulan-pro.com 1-800-554-6723 Instruction Manual Manual de Instrucciones Manuel d’Instructions PP3516AVX / PP4218AVX ESPAÑOL WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e enstrucciones de seguridad.

Chain Saw User Manual Free Download. Chainsaw Operator’s Manual. Chains for Chainsaws Free Instruction Manual Download PDF. Years covered by this manual: 2006.

El no hacerlo puede resultar en lesiones graves. AVERTISSEMENT: Lire le manuel d’instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Poulan PRO 1030 Stevens Creek Road Augusta, GA 30907 Poulan PRO 5855 Terry Fox Way Mississauga, Ontario L5V 3E4 FRANÇAIS 545137248 11/30/06 IDENTIFICATION OF SYMBOLS WARNING! This chain saw can be dangerous! Careless or improper use can cause serious or even fatal injury. Always wear appropriate ear protection, eye protection and head protection. XX_ Read and understand the instruction manual before using the chain saw. Measured maximum kickback value without chain brake for the bar and chain combination on the label. Always use two hands when operating the chain saw. WARNING! Contacting the guide bar tip with any object should be avoided; tip contact may cause the guide bar to move suddenly upward and backward, which may cause serious injury. Starting Reminder Move ON/STOP switch to the ON position. Chain Tensioning Lift lever on bar knob and turn counterclockwise 1 turn to loosen bar clamp. Slowly press primer bulb 6 times. Pull choke/fast idle lever out to the full extent (to the FULL CHOKE position). Pull the starter rope sharply 5 times with your right hand. Turn adjusting wheel (downward direction) to tension chain until chain solidly contacts bottom of guide bar rail. While lifting tip of guide bar, tighten bar knob (clockwise) securely. Hand tighten only! Return lever on bar knob to original position. Push the choke/fast idle lever in to the HALF CHOKE position. Pull the starter rope sharply with your right hand until the engine starts. 2 SAFETY RULES WARNING: Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent accidental starting when setting up, transporting, adjusting or making repairs except carburetor adjustments. Because a chain saw is a high-speed woodcutting tool, special safety precautions must be observed to reduce the risk of accidents. Careless or improper use of this tool can cause serious injury. PLAN AHEAD S Read this manual carefully until you completely understand and can follow all safety rules, precautions, and operating instructions before attempting to use the unit. S Restrict the use of your saw to adult users who understand and can follow safety rules, precautions, and operating instructions found in this manual. S Wear protective gear. Always use steel-toed safety footwear with non-slip soles; snug-fitting clothing; heavy-duty, non-slip gloves; eye protection such as non-fogging, vented goggles or face screen; an approved safety hard hat; and sound barriers (ear plugs or mufflers) to protect your hearing. Regular users should have hearing checked regularly as chain saw noise can damage hearing. Secure hair above shoulder length. Hearing Protection Snug Fitting Clothing Safety Hat Eye Protection Heavy Duty Gloves OPERATE YOUR SAW SAFELY S Do not operate a chain saw with one hand. Serious injury to the operator, helpers, bystanders or any combination of these persons may result from one-handed operation. A chain saw is intended for two-handed use. S Operate the chain saw only in a well-ventilated outdoor area. S Do not operate saw from a ladder or in a tree. S Make sure the chain will not make contact with any object while starting the engine. Never try to start the saw when the guide bar is in a cut. S Do not put pressure on the saw at the end of the cut. Applying pressure can cause you to lose control when the cut is completed.

Wikipedia’s page for Poulan

Company Web Site: www.poulanpro.com